The production of Fiberglass statues can be roughly divided into the following aspects: Materials: clay, sludge, wood, glass, Fiberglass powder, clay knife.

Scribing shape: the bottom of the board or glass plate, the mud is sketched, the mud board is like paper, and the knife is used as a pen-line rectangle to ensure accurate contour and vivid image.

Positioning: Firstly, according to the needs of the decorative body, the height of the relief can be determined. The decorative relief of the outdoor and the distant view can be high; the close-up and indoor decoration should below.

The height standard of the relief is called “standing position”, that is, the edge of the relief image is perpendicular to the straight surface of the bottom plate. It is the ruler that determines the height of the relief and the edge that determines the contour image of the relief shape.

The fourth method of making Fiberglass sculpture

The fourth method of making Fiberglass sculpture

When the standing position is established, it enters the details of the image and the structure of the structure. It is expressed from the oblique position and the round position. The oblique position is powerful and the circular position is excessively soft. In addition to the positioning technique, the technique of embossing includes brush strokes, knife marks, mud, texture, and sculpture shaping techniques.

Generation: Decorative relief is different from proportional compression relief. It adheres to the flat surface of the relief surface. This is not only the need for visual appreciation but also the requirements of practicality and architecture. This requires the technique of embossing to apply the image to the image. To maintain the flat surface of the embossed surface, and to achieve the effect of the three-dimensional image, it is one of the special techniques and decorative techniques for decorative relief.

Overmolding: After the floating sculpture is finished, the glass fiber reinforced plastic can be poured. First, use a Fiberglass to make a negative mold (the ratio of Fiberglass powder to water is 1:1). Dry the female mold and apply soapy water to the surface to form a barrier mold.

When pouring the Fiberglass, avoid bogey and irrigating, and slowly fill the flow until the Fiberglass liquid is fully filled, so as to avoid the bubbles and ensure the quality of the work. The embossing is turned over, and if it is processed and colored, it can be directly sprayed with an advertising color, which can be stoned. It can also be made into a metal effect, with a varnish base, and then painted with oil painting color and gold and silver powder with a metal texture, an embossed ornament Serve.