There are many types of Fiberglass sculpture molds, the following is a detailed introduction:

The gypsum mold gypsum model is heat-resistant, inexpensive, has a small thermal conductivity, and has good copy ability. Generally used to make master molds. Easy to manufacture, suitable for large products. But not durable, afraid of impact, slow drying.

Fiberglass sculpture mold type

Fiberglass sculpture mold type

It is mostly used for single products and complex linear products, such as embossing, small and medium-size round sculptures.

Most of the gypsum used is hemihydrate gypsum, that is, plaster of Paris. Like the cement mold, the brick base and wood can be used as the skeleton foundation and then covered with a plaster layer. In order to increase the rigidity and prevent cracking, sufficient filler can be added to the gypsum, such as adding quartz to reduce shrinkage and cracking and adding cement (gypsum: cement = 7:3) to increase the strength. It has also been proposed to add a proper amount of latex with gypsum, dilute with water to make a mold, and the strength is good, and powder is not obtained. The plaster mold can be used as a master mold for a low melting point alloy mold to cast the alloy in a hot state.

When casting a gypsum mold (sub-mold) with a gypsum master mold, the surface of the master mold should be coated with a separating agent such as potassium soap solution, transformer oil, edible oil, 20% stearic acid, 80% kerosene, or gasoline ten Vaseline… The plaster mold can be repaired by taking a gypsum powder with a water pan. The gypsum mold drying process is: (60 ~ 120) ° C / (4 ~ 5) L, after natural cooling, gently polished with metallographic sandpaper, and then (100 ~ 150) ° C / (8 ~ 10) L, ( 200 ~ 230) ° C / (20 ~ 24) L drying.

Fiberglass sculpture rubber mold is generally made of silicone rubber and polyurethane resin. It is used to make complex reliefs, round sculptures, and various shapes. It is not used alone. It must be composed of other materials such as gypsum sleeve mold, usually used in molds. A part of the line type that is poured or overlapped and cannot be directly demoulded, because it has a certain softness. When the outer mold is demolded, it can be pulled out at wills, such as an animal such as a lion or a dragon, or a bodhisattva or a cartoon character. Use this method when the batch size is not large.